Product Categories
Timeguard, proud to be a part of the Theben group.
BSI Registered. Certificate No. Q05884
System Devices
Power Supply 640 mA
The KNX voltage supply generates and monitors
the KNX system voltage by means of the integrated reactor. The bus line is decoupled from the KNX voltage supply. The connection to KNX is made with a bus terminal. When the reset button is pressed, a reset is triggered for 20 seconds(regardless of how long the button remains
pressed). The bus line is enabled and the bus users connected to this bus line are reset to the basic status. If a longer reset is needed, the bus terminal must be disconnected from the supply voltage. A 30 V DC auxiliary voltage output is provided by an additional terminal.
- 30 V DC
- DIN rail fixing
- 640 mA current
- Integrated choke
- Switch for resetting the bus line
- Powers up to 64 EIB/KNX devices
Specification
| Power supply | 230 V AC, 50…60 Hz |
|---|---|
| Voltage range | 195…255 V AC, 45…65 Hz |
| Power consumption | Max. 45 VA |
| Dissipation | Max. 6 W |
| Outputs | |
| EIB-output | 1 line with integrated reactor |
| EIB nominal voltage | 30 V DC ±2 V, SELV |
| Auxiliary voltage output | 1 (without reactance) |
| Auxiliary voltage, nominal value | 30 V DC ±2 V, SELV |
| Nominal current (total) | 640 mA, short-circuit proof (sum of KNX and 30 V outputs) |
| Short-circuit current | Max. 1.4 A |
| Mains failure ride-through interval | Min. 200 ms |
| Operating temperature range | –5 °C … +45 °C |
| Degree of protection | IP 20 according to EN 60 529 |
| Housing | 90 × 108 × 64 mm |
NOTE: Timeguard has a policy of continuous product development and reserve the right to alter specifications at any time. Therefore, unavoidable differences between product and website specifications may occur, for which liability cannot be accepted by Timeguard.