Blinds

JME4 24VDC 4-Channel Blind Actuator (Extension Module)

The blind actuators of the JMG 4 24VDC type are suited for use with interior blinds and sun roller blinds.

By the use of these blind actuators, the rotational direction and running times of the motors can be switched on and off. Hand switch Up/Down.

  • 4 driving channels 24VDC
  • Modular expandability from four to eight blinds
  • Capability of addressing blind (including louver) or shutter positions directly for: canvas blinds, blinds, shutters and several sun and sight protections, skylights and ventilation flaps
  • Optimised repeatability of the programmed louver position
  • With the extra window contact module you can stop the inside blinds going up and down when the window is open

« Back to product section

Specification

Operating voltage 230 V/240 V ± 10%
Rated frequency 50 Hz
Product consumption Max. 4 VA
Current consumption of bus ≤ 8 mA
Load circuit 24 V DC
Contact material AgNi
Type of contact Closing contact, floating
Switching capacity 5 A (24 V DC). 5 A (12 V DC)
Permissible ambient temperature –5 °C … +45 °C
Protection class II (after correct installation)
Protection type IP 20 in compliance with EN 60529
Housing 45 × 105 × 60 mm
Weight 450 g

NOTE: Timeguard has a policy of continuous product development and reserve the right to alter specifications at any time. Therefore, unavoidable differences between product and website specifications may occur, for which liability cannot be accepted by Timeguard.