Outdoor Multi-Connector Boxes

Timeguard’s WP401 Outdoor Multi-Connector Box comes complete with
a 4 way, 13A socket strip providing the ideal solution for outdoor plug-in
power. Ideal for transformer linked garden lighting, fountain pumps, pool
filters etc.

The new WPL02 Outdoor Power Connect-2 Mini Box shares its features
and benefits in a compact 2-way 13A socket strip size.

Installing a WP401 Multi-Connector Box

For permanent installation the product should be fastened to the wall using
four No. 8, min 1.5in. long wood screws. Note – installation onto an uneven
surface may cause the base to twist and prevent the lid from properly
sealing, always check that the lid is properly located. If it is not, remove the lid, slacken one or more of the four base fixing screws and try again.

For temporary installation the Multibox can be supported on the picture
hook located at the top rear centre of the product.

If conduit is to be used there must be sufficient drainage from the lowest
points of the conduit, and waterproof cable glands or
conduit entries must be used.

If two cable entry positions are used with metal conduit, then earth
continuity between the conduits must be maintained.

If conduit is attached through the side or top surface then the drain hole
must be drilled out (see fig 3). Opening this drain hole
will reduce the IP rating of this product.

Purchase the required length of cable to connect the socket strip provided
to the supply outlet. Use 3 core 1.5 sq. mm for shorter
lengths or 2.5 sq. mm as an option for longer lengths. These cables are
readily available at most DIY stores.

Connect this cable to the socket strip following the instructions provided on
the reverse of this instruction leaflet.

Position socket strip on the velcro fastenings and press down. Plug in
output plugs/transformers as required and position their
leads in the waterproof slots as shown in figs 1 and 2.